  
MHHnovotegra for Corrugated Eternit and Sandwich Roofs
The type of underconstruction is critical in determining how your modules will be mounted on corrugated Eternit and sandwich roofs. On roofs with a wooden substructure, our standard stock bolts can be used to fasten the railing directly into the roof beams.
Roof Parallel Installation
In a roof parallel horizontal configuration, the C-rails are attached to the stock bolts with a simple screw fastener with an M12 locking bolt. This secures a quick, strong and reliable connection. For a vertical configuration, the C-rails are installed in a cross configuration and are also fastened with reliable locking bolts. To mount the modules in a vertical insatllation, the C-rails are fixed in a cross configuration and Thanks to proven MHH clamp technology, modules can be quickly and safely mounted onto the railing, regardless of whether they are horizontally or vertically mounted. All of our end and middle clamps are shipped ready to install and are also available in anodized black.
Elevated Installation
If the roof angle is below 20 degrees, an elevated installation is recommended for corrugated Eternit and sandwich roofs. We offer additional components from the MHHnovotegra family for exactly this purpose. The MHHnovotegra system is mounted directly to the substructure with either our hanging bolt set HP for wood beams or SP for steel beams, depending on your roof configuration. This ensures that the system is stabilized by the roof beams and not just the superstructure. The C-rail is then attached to the hanging bolt with the use of a simple lock bolt and serves as the mounting frame upon which the base railing can be securely installed.
For an elevated installation, the base rail is fastened directly to the C-rail with our fastening set. Depending on the desired angle of elevation of your modules, you can then choose from five different lengths of module supports. The specially designed module anchors are attached directly to the module frames, the whole module is mounted diagonally into the base rail, and the module supports are attched to the elevated edge of the module frame. Each module support has ten centimetres of threading so that the angle of the modules can be fine-tuned. This allows you to achieve the exact desired angle and to create a perfectly uniform module array.
Andvantages
Datasheets
Diese E-Mail-Adresse ist gegen Spambots geschützt! Sie müssen JavaScript aktivieren, damit Sie sie sehen können. |
MHHnovotegra for Corrugated Eternit and Sandwich Roofs: MHH Datasheet
